Moeller Marine AWB2700-1428GB User Manual download pdf (Page 25)

12/01 AWB2700-1428GB

3 Creating an Example Project

The following example is used to illustrate the use of the XSoft

software. A project is created by creating a configuration and a

program. After the project is downloaded, the program can be

tested.

A configuration is made with the XSoft configuration editor. This

enables input/output modules such as XI/ON modules and

CANopen and PROFIBUS-DP modules to be configured locally and

remotely. The hardware configuration shown in Figure 39 is the

basis of the configuration.

In the first part of this example you will configure the XC600 PLC.

It is configured with two digital input modules and two output

modules (relays). A program is shown that links the inputs

together in an AND sequence and sends the result to an output.

In the second part, you will add a remote I/O combination (2 input

modules and 2 output modules) to the XC600. This is connected

to the master via the PROFIBUS-DP network. An additional

program will link two inputs and send the result to an output.

In the third part, a remote WINbloc output module is added to the

XC600. This is connected to the master via the CANopen BUS

network. An additional program is used to send two values to the

outputs.

Figure 39: Configuration of the example project

The XC600 consists of:

XC-SYS1

XC-CPU601-E4M

XC-NET-CAN

XC-NET-DP-M

XC-POW50-XION-UPS

XC-ADP-XION

Operator module

CPU

CANopen module

PROFIBUS-DP module

Power supply module

Base module

PROFIBUS-DP

CANopen-BUS

Bridge

Modules:

2 digital inputs

2 digital outputs

Modules:

Gateway

Power supply module

2 digital inputs

2 digital outputs

Bridge

WINblock

output module

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 53 54

Comments to this Manuals

No comments

Moeller Marine AWB2700-1428GB User Manual Page 25

Comments to this Manuals