Moeller Marine AWB2700-1428GB User Manual download pdf (Page 38)

Functions of the Operator

Module

12/01 AWB2700-1428GB

Startup with configuration scan

On startup the PLC system always scans the modules of which the

PLC is made up. If the configuration does not change, for example,

after commissioning has been completed, the configuration can be

”frozen” for diagnostic tasks.

For this disable the AUTOCONFIG function:

X Choose MAIN MENU r DEVICE r HARDWARE r

AUTOCONFIG.

The cursor will be positioned on ON:

X Turn the MSS until the display shows OFF.

X Press the MSS. The word ENTER will appear on the display.

X Press the MSS to return to the menu.

This function can be re-activated at any time.

The next time that the PLC is started up the PLC will detect if any

modules are missing or faulty. This will be indicated by the lit SF

LED.

The following error text will appear in the DIAGNOSTICS r ERROR

menu:

The number 1 in the designation XC-NET-1 indicates the module:

Error and event messages

Error messages

The SF LED will be lit in the event of an error, and ! will appear in

the display.

The following errors will cause an error message to be output:

The type of error with date and time is displayed in the Diagnostics

menu under ERROR.

The error message can be deleted as described below, together

with the event messages:

X Choose menu item MAIN MENU r DIAGNOSTICS r CLEAR.

The display shows:

X Turn the MSS until NO is replaced by YES.

X Press the MSS.

X Turn the MSS: BACK will be replaced with ENTER.

X Press the MSS to reach the next higher menu.

Event message

Events are written with the time and date for additional infor-

mation.

Events include:

The events are displayed via DIAGNOSTICS r EVENT. Turn the

MSS to go through each message in the list.

Calling up the EVENT menu will clear the exclamation mark. All

event messages are cleared with the error message via the CLEAR

menu item in the diagnostics menu.

Number (Hardware) address of the module

0 CE000

CC000

D4000

AUTOCONFIG:

BACK

05.12_15:32

XC-NET-1

NOT DETECTED

BACK

15:21:10 !P

RUN-P

SAWING.PRO

>MAIN MENU

From the system PROG: ??? – No program loaded. Other

system errors are listed in the Appendix

From the operator

module

Battery discharged or not present

From the local I/O

modules

XION not detected

Other error messages are explained in the Appendix.

The message will be retained if the error is still present.

System Start program or Stop program

XI/ON modules

XION Diag extended, an error has occurred, e.g.

short-circuit at an output, that is displayed via the

extended diagnostics.

XI/ON param conf failed – the set configuration

does not match the actual configuration

CLEAR:

BACK

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Comments to this Manuals

No comments

Moeller Marine AWB2700-1428GB User Manual Page 38

Comments to this Manuals